Craftsman 17125455 Operating Instructions Manual page 34

THE FOLLOWING DESCRIBES THE PROCEDURE TO
BEFOLLOWED FOR CUTTING CORNERS 2AND 4
CORNERS 2AND 4 arecutinthesame w ay as1and 3
except they are positioned on the right side of the Dovetail
Jig as shown Figure 54
.
[,_CAUTION I
BEFORE MAKING ANY CUTS
MAKE SURE THAT THE BIT WILL NOT CUT INTO THE
BASE OR ANY OTHER COMPONENT OF THE DOVE-
TAIL JIG,, THIS CAN CAUSE DAMAGE TO THE DOVE-
TAIL JIG,,
•
I "_cAUTION t
NEVER LIFT THE ROUTER
UPWARDS WHEN THE ROUTER IS ON AND THE
ROUTER BIT ROTATING OR WHEN THE GUIDE BUSH-
ING IS NEAR TO OR TOUCHING THE TEMPLATE° THIS
CAN CAUSE DAMAGE TO THE DOVETAIL JIG.
• After the cut has been made, the workpieces should fook
Iike those illustrated in Figure 53
• The finished front, back, and sides should look iike those
in Figure 46
• Before gluing the front, back, and sides together,
some provision must be made for installing the bot-
tom, such as dadoing or cutting a groove around the
inside of the drawer parts°
• Your drawer is now ready to be glued together
FIGURE 54
TOP OF THE BASE \
\
AUXILIARY(As NEEDED)TEMPLATESUPPORT \\ _\
'INSIDE SURFACE" SHOULD BE
VISIBLE ON THIS SURFACE
DRAWER BACK
/
/
FRONT OF THE BASE "/
DRAWER RIGHT SIDE
"iNSIDE SURFACE" SHOULD BE VrSIBLE ON THIs SURFACE
NOTE: WORKPIECES WILL BE POSITIONED ON THE JIG AS
34