Craftsman 17125455 Operating Instructions Manual page 12

13With thecam handle pushed inagainst the base,
position theretainer agains! the side wall o fthe base, as
shown i nFigure 1 3The retainer should b arely t ouch the
side wall o fthe base The purpose oftheretainer isto
prevent orminimize the side-to-side ofthecam handle and
pivot s haft
14Assemble the other c am handle totheother end ofthe
pivot s haft using a 13/64" 1Dx 9/16" OD washer and
a#10-32 X5/8" long panhead machine screw, asshown i n
Figure 1 4
15 Make s ure that t he cam handle lines upwith thecam
handle atthe other e nd ofthepivot s haft and that t he
end
of the cam handle fits into the hole in the base
16 Tighten the screw securely
17 Rotate one of the cam handles-It should rotate freely
and move the template supports
18 If this does not happen, loosen the screw on the retain-
er and move the retainer away from the side wall slightly
19 Securely retighten the screw
20 If there is too much side-to-side movement (play) of
the cam handles; loosen the screw in the retainer and
move the retainer closer to the side wall of the base
21 Securely retighten the screw
FIGURE 13
_L OF BASE
FIGURE 14
LEFT TEMPLATE SUPPORT
j PIVOT SHAFT
/
J // / #t0_32 X 5/8" LONG
\
\ X 9/16" O D WASHER
\" CAM HANDLE
12