Oven Air Vents; Upper Control Panel - GE Profile JGB900 Owner's Manual And Installation Instructions

www.GEAppliances.com
Vent appearance and location var_
Oven Air Vents
Never block tile vents (air openings) of tile
range. Tile}' provide tile air inlet and outlet
that are necessa_ T fin" the range to operate
properly with correct COll/b/istlon.
_dr openings are located at the rear ot
tile cooktop, at tile top and bottom ot tile
oven doo_; and at tile bottom of tile range,
under tile wamfing drawer
CONTROL LOCKOUT
Upper Control Panel
On models so equipped, lock out the touch
pads before cleaning.
See tile Control Lockoutinlbmmtion in tile
Special features of your oven control section
in this manual.
Clean up splatte_ with a damp cloth.
Yell I//aV also rise a
glass
cleanei:
Remove heavier soil with warn/soapy water:
Do not rise abrasives ot any kind.
Unlock the touch pads after cleaning.
PullflTeknobstraightoff the stem.
Lower Control Panel (Front Manifold Panel) and Knobs
It's a good idea to wipe tile control panel
alter each
tlse of
tile oven. Use a damp
cloth to clean or iJnse. For cleaning, tlse
mild soap and water or a 50/50 solution el
vinegar and warn1: For rinsing, use clean
wateI: Polish dry with a soft cloth.
Do not use abrasive cleansei5, strong liquid
cleanei_, plastic scouring pads or oven
cleanei_ on tile control panel--they will
damage tile finish.
Do not try to bend knobs by pulling them
up oi" down or by hanging a towel or other
such loads. This can damage the gas \;dye
shatt.
Tile control knobs may be removed fin"
easier cleaning. To remove a knob, pull it
straight off tile stem. If knob is difficult [o
remove,
place
a towel or
dishcloth
between
tile knob and control panel and pull genfl>
Wash the knobs in soap and water or a
vinegar and hot water solution,
Metal parts can be cleaned with soap and
watei: Do not use steel wool, abrasives,
}lI//IllOIli}l_
acids oi" co1//111eF(-'ial oven
cleanei_. Dry with a soft cloth.
39