Remote Control - Sharp HT-X1W Operation Manual

Remote control

HT-X1W
ENGLISH
! Battery installation
1 Remove the battery cover.
2 Insert the supplied batteries according to the direction indi-
cated in the battery compartment.
When inserting or removing the batteries, push them toward the
battery terminals.
3 Replace the cover.
Precautions for battery use:
" Replace all old batteries with new ones at the same time.
" Do not mix old and new batteries.
" Remove the batteries if the system will not be used for long peri-
ods of time. This will prevent potential damage due to battery
leakage.
Caution:
" Do not use rechargeable batteries (nickel-cadmium battery, etc.).
" Installing the batteries incorrectly may cause the system to mal-
function.
Battery removal:
Remove the battery cover. Push each battery toward the
terminal and take them out.
E-23
Notes concerning use:
" Replace the batteries if the operating distance is reduced or if the
operation becomes erratic. Purchase 2 "AAA" size batteries (UM-
4, R03, HP-16 or similar).
" Periodically clean the transmitter on the remote control and the
sensor on the main unit with a soft cloth.
" Exposing the sensor on the main unit to strong light may interfere
with operation. Change the lighting or the direction of the main
unit if this occurs.
" Keep the remote control away from moisture, heat, shock, and
vibrations.
! Test of the remote control
Check the remote control after checking all the connections (see
pages 16 - 22).
Point the remote control directly at the remote sensor on the main
unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now,
you can enjoy music.
" The main unit is equipped with 2 remote sensors. Use them
according to the installation method as shown below.
Main unit
Remote sensor
battery
05/2/2 HT-X1W(LA)E3.fm
0.2 m - 6 m
(8" - 20')
TINSZA048AWZZ