Remote Control - Sharp SD-AT100H Operation Manual

Remote control

„ Battery installation
1 Remove the battery cover.
2 Insert the batteries according to the direction indicated in the bat-
tery compartment.
When inserting or removing the batteries, push them towards the
nals.
3 Replace the cover.
Precautions for battery use:
z Replace all old batteries with new ones at the same time.
z Do not mix old and new batteries.
z Remove the batteries if the unit is not to be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
z Do not use rechargeable batteries (nickel-cadmium battery, etc.).
z Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:
z Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 "AAA" size batteries (UM-4, R03, HP-16 or similar).
z Periodically clean the transmitter on the remote control and the sensor on the unit
with a soft cloth.
z Exposing the sensor on the unit to strong light may interfere with operation.
Change the lighting or the direction of the unit.
z Keep the remote control away from moisture, heat, shock, and vibrations.
„ Test of the remote control
Face the remote control directly to the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy your
battery termi-
system.
„ How to open the sliding cover
This remote control has buttons on its front and back.
To use the buttons on the back, open the sliding cover.
Notes:
z When operating the buttons on the back of the remote control, be careful not
to press the buttons on the front side. The unit may malfunction.
z Close the sliding cover on the back whilst using the buttons on the front side.
z You can control the TV and VCR with this remote control (pages 65, 66).
01/11/16
Remote sensor
0.2 m - 6 m
(8" - 20')
Slide the cover
until it clicks.
SD-AT100H(H)E2.fm
SD-AT100H
ENGLISH
E-18