Battery Installation; Turning The Power On - Sharp HT-CN650DVW Operation Manual

Battery installation

1 Open the battery cover.
2 Insert the supplied batteries according to the direction indicated in
the battery compartment.
When inserting or removing the batteries, push them towards the
terminals.
3 Close the cover.
Precautions for battery use:
Replace all old batteries with new ones at the same time.
Do not mix old and new batteries.
Remove the batteries if the unit is not to be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
Incorrect installation may cause the unit to malfunction.
Battery (battery pack or batteries installed) shall not be exposed to excessive heat
such as sunshine, fire or the like.
Notes concerning use:
Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 "AAA" size batteries (UM-4, R03, HP-16 or similar).
Periodically clean the transmitter on the remote control and the sensor on the unit
with a soft cloth.
Exposing the sensor on the unit to strong light may interfere with operation. Change
the lighting or the direction of the unit.
Keep the remote control away from moisture, heat, shock, and vibrations.

Turning the power on

Test of the remote control
Check the remote control operation after making all the connections (see pages 12 -
18).
Point the remote control directly at the remote sensor on the unit.
battery
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy your
system.
0.2 m - 6 m
(8" - 20')
ON STAND-BY
To turn the power on
Power stand-by indicator
Press the ON/STAND-BY button.
If the power does not turn on, check the AC power lead is plugged in properly.
Remote sensor
ON STAND-BY OPEN CLOSE
PRESET MUTE PRESET
SLOW PLAY PAUSE OSD
TUNING STOP TUNING
FUNCTION SETUP
ENTER
HT-CN650DVW
19