Remote Control Battery Installation; Test Of The Remote Control - Sharp HT-SBW460 Operation Manual

Remote control
Battery installation
1.
Open the battery cover.
2.
Insert the batteries according to the terminal
indicated in the battery compartment. When
inserting or removing the batteries, push it
toward the (–) battery terminals.
3.
Close the cover.
Caution:
● Replace all old batteries with new ones at the
same time.
● Do not mix old and new batteries.
● Remove the batteries if the unit will not be
used for a long period of time. This will prevent
potential damage due to battery leakage.
● Do not use rechargeable batteries (nickel-
cadmium battery, etc.).
● Installing the batteries incorrectly may cause the
unit to malfunction.
● Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such as
sunshine, fire or the like.
Notes concerning use:
● Replace the batteries if the operating distance
is reduced or if the operation becomes erratic.
Purchase 2 "AAA" size batteries (UM/SUM4,
R3, HP-16 or similar).
● Periodically clean the transmitter on the remote
control and the sensor on the unit with a soft
cloth.
● Exposing the sensor on the unit to strong light
may interfere with operation. Change the lighting
or the direction of the unit.
● Keep the remote control away from moisture,
heat, shock, and vibrations.

Test of the remote control

The remote control can be used within the range
shown below:
E-5
Remote sensor
0.2 m - 6 m