Sharp HT-CN650DVW Operation Manual page 21

Change the system with conventional TV connecting
If you use a conventional TV, you must select the INTERLACE at "Video Setup Page" (see page 22).
INTERLACE mode is use for normal video output.
For conventional TV connection, please refer to page 14.
Change the system to a TV with Progressive-Scan
If you use TV with Progressive-Scan capability and connect it to the COMPONENT VIDEO OUT sockets of the DVD main unit (see page 15), you must select the
PROGRESSIVE-SCAN (P-SCAN).
Setup menu Selectable parameters (* indicates default setting)
GENERAL
SETUP
PAGE
AUDIO
SETUP
PAGE
(*1)
Selects the dynamic range compression to fit the individual listening situation of the audience. This function can be used in DVD playback.
Depending on the disc, sounds may become too loud or inaudible during playback. Dolby Digital's dynamic range control allows you to adjust the sound range.
TV DISPLAY NORMAL/PS*
NORMAL/LB
WIDE
WIDE SQUEEZE
ANGLE ON*
MARK OFF
OSD LANG ENGLISH*
RUSSIAN
FRENCH
SPANISH
SCREEN ON*
SAVER
OFF
LAST ON
MEMORY
OFF*
SPEAKER TEST TONE ON
SETUP OFF*
SPDIF SPDIF SPDIF OFF
SETUP OUTPUT SPDIF/RAW
SPDIF/PCM*
LPCM 48K*
OUT 96K
DOLBY DYNAMIC(*1) FULL
DIGITAL
3/4
SETUP
1/4
OFF*
CHANNEL
DELAY
Description
The screen mode should be set according to the connected TV type (for details,
see page 24).
You can select the desired OSD (On Screen Display) language for the setup
menu or playback control screen.
A screensaver appears.
The screensaver is disabled.
If accidently push ON/STAND-BY or OPEN/CLOSE button during playback
mode, you can resume playback from the point playback is stopped after power
on back or you push the OPEN/CLOSE button to close the disc tray.
Last memory not function.
You can check speaker output (see page 49).
Useful whilst using HDMI cable.
When playing a disc recorded with Dolby Digital or DTS, the corresponding digital
signals will be output from the HDMI Output socket.
PCM: Choose this setting if the HDMI TV cannot support Dolby Digital or DTS
to avoid noise or mute from the TV.
RAW: Choose this setting if the HDMI TV can support Dolby Digital or DTS.
Select the sampling frequency at 48 kHz/16 bit or 96 kHz/24 bit capability after
you select SPDIF/PCM at SPDIF SETUP.
Audio with fully compressed dynamic range.
Audio with partially compressed dynamic range.
Audio with uncompressed dynamic range.
Adjust the delay time of the speakers (for details, see page 48).
HT-CN650DVW
21