Alarm And Sleep Operation - Sharp DK-A1H Operation Manual

Alarm and sleep operation

DK-A1H
DK-A1H(BK)
ENGLISH
Alarm
The unit turns on and play desired source (iPod, TUNER or AUX) or
Buzzer sound for 30 minutes.
Before setting the alarm:
1 Check that the clock is set to the correct time. (refer page 10)
If it is not set, you cannot use the alarm function.
2 For iPod playback: insert iPod to the unit. (refer page 12)
3 For TUNER: Set preset memory. (refer page 15)
Setting the alarm content
1
Press and hold the ALARM button for more than 2 seconds.
2
Press the
Press the ALARM button.
3
If TUNER is selected, press the
preset station. Press the ALARM button.
4
Press the
Press the ALARM button.
5
Press the
Press the ALARM button.
6
If other than BUZZER is selected in step 2, press the
or VOL (+ or –) button to select volume.
Press the ALARM button.
Notes:
If steps 1 - 6 above are done using the remote control, press the
ALARM ON/OFF button on main unit to activate the alarm.
To switch off subwoofer illumination and display in demonstration
mode, press the E SOUND/DEMO button.
E-21
or button to select source or buzzer.
or button to select a
or button to adjust the hour.
or button to adjust the minute.
Changing alarm source only
After source is selected in step 2, press and hold the ALARM button.
If TUNER is selected, press and hold the ALARM button after preset
station is selected in step 3.
The time and volume will be automatically set to the previous
setting.
Activating and deactivating the alarm
Press the ALARM ON/OFF button on main unit to activate or
deactivate the alarm function. When activated:
During power on, "ALARM" will appear.
During stand-by mode, ALARM indicator will light up.
Switching off the sound and display
To turn off the sound and display, press either CLOCK button,
ON/ STAND-BY button or E SOUND/DEMO button.
Checking the alarm setting
Press the ALARM button.
The selected source or buzzer type will blink.
The unit will display the alarm time for 3 seconds.
During stand-by mode, the display will remain for 6 seconds.
Example: The time is 10:00 AM and iPod function is selected.
Notes:
Buzzer sound will be output from right speaker only.
Alarm will not activate during power on mode.
When iPod is selected in step 2, if iPod unit is not detected during
alarm activation, source will automatically change to BUZZER 1.
When performing alarm using another unit connected to AUX,
select AUX in step 2. The unit will turn on and enter the clock
or
function automatically, however, the connected unit to AUX will
not turn on or off.
When the entire preset memory is erased (page 15), source will
automatically change to BUZZER 1 even if TUNER is pre-
selected (step 2).