Sharp FO-130 Operation Manual page 43

c
ANSWERING MACHINE
QUIET DETECT START TIMING
This setting can be used to delay the start of Quiet Detect Time if the latter is enabled.
We recommend that you only use this function if there is a long pause between the time the
answering machine answers a call and the beginning of the outgoing message (a pause is
sometimes added before the message to allow clear detection of possible fax tones). In this case,
delaying the start of Quiet Detect Time prevents the fax from cutting in before voice callers can
leave a message.
You can set Quiet Detect Time to start at any time from 1 to 15 seconds after the answering machine
answers, or enter "00" for no delay.
l
The factory setting is "00" (off).
))
Hint:
l
As a general guide, the start timing setting should be slight& longer than the pause before the
outgoing message.
Make the setting by pressing the panel keys as follows:
I,
1
Step
~
Press these keys:
~
i
Comments
1~
j!
1
i
;,,C,,,; ~
Enter A.M. MODE.
!
,2'El
Scroll to QUIET START TIME.
j
3
IO
Set the start timing by entering a two-digit number
equal to the number of seconds ("01" to "15" sets), or
(Example) enter "00" for no delay.
I
STOP
ii
4
ji
mcl
Press STOP to return to STAND-BY.
I
USING YOUR FAX WITH OTHER DEVICES