Thermal Protector - PLUS Vision WorkForce V-1100 User Manual

When the STATUS Indicator is Lit/Flashes
STATUS Indicator
STATUS
Lit red
STATUS
Lit red

Thermal Protector

When the internal temperature of the projector becomes abnormally high, the STATUS indicator will flash
red (at a rate of once per second) and the POWER indicator will light red.
The thermal protector is activated and the power of the projector is switched off simultaneously.
Should this occur, proceed with the following actions.
1. Switch off the power and disconnect the power plug from the wall outlet.
2. Check the following matters and take the required measures.
When the projector is being used in a location that has a high ambient temperature, set it up again in
a cool location. Check the outflow and intake holes and clean them if they are obstructed.
3. Wait about 60 minutes until the temperature of the projector drops.
If after having performed the above matters, the problem still has not been solved, please contact your
store of purchase.
POWER Indicator
POWER
When power is on:
Lit green
When power is off:
Lit amber
POWER
Lit amber after 90 seconds
of flashing in amber
Action to Take
It is timer to replace the lamp.
The lamp timer has exceeded 1,000 hours.
Replace the lamp cartridge.
The lamp's service life has ended.
The lamp timer has exceeded 1,100 hours. The lamp
will not light. Replace the lamp cartridge.
E-62