Preparing The Remote Control; Button Battery Replacement - PLUS Vision WorkForce V-1100 User Manual

Epson data projector user's manual v-1100

Table of Contents

Preparing the Remote Control

Replacement Method

Insert the tip of a ballpoint pen or some other pointed object into the hole of the

battery holder, then pull out to open.

Remove the old battery and install a new button battery with (+) side facing upward in the battery holder.

Purchase a CR2025 type battery for replacement.

Insert the battery holder into the remote control and push in until the battery

holder closes with a "click" sound.

CAUTION

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type (CR2025) recommended by the manufacturer.

Dispose of used batteries according to your local regulations.

Using the remote control for the first time

The battery compartment is fitted with a transportation insulation sheet at

the time of shipping. Pull out the sheet and remove it. The remote control is

now ready for use.

E-13

Table of Contents

Do you have a question about the WorkForce V-1100 and is the answer not in the manual?