Special Menu Setting [Special Setup]; Chroma Level Adjustment [Chroma Gain]; Aperture Level Adjustment [Ap Gain]; Pedestal Level Adjustment [Pedestal] - Panasonic WV-CP300 Operating Instructions Manual

Special menu setting [SPECIAL SETUP]

The special menu setup is performed including the setting of the camera image quality and the
communication configuration when a decoder is used. The following settings are to be config-
ured on the "SPECIAL SETUP" screen displayed from the top screen. Refer to page 5-6 for
how to call up the screen.
"SPECIAL SETUP" screen
**SPECIAL SETUP**
....I..160
CHROMA GAIN
...I... 32
AP GAIN
.I..... 15
PEDESTAL
...I...
HUE
-
PIX OFF
COMMUNICATION COAX
CAMERA RESET PUSH SET
SER.NO. XXXXXXXX
RET TOP END
F Chroma level adjustment [CHROMA GAIN]
Use the [RIghT ] or [LEfT] button to adjust the color density of the camera image. When the
level indicator moves in the "+" direction, the color becomes thicker, and when the level indica-
tor moves in the "–" direction, the color becomes thinner. Be sure to view a vector chromaticity
indicator or a monitor when the adjustment is performed.
G Aperture level adjustment [AP GAIN]
Use the [RIghT] or [LEfT] button to adjust the image quality. When the level indicator moves in
the "+" direction, the image becomes sharper, and when the level indicator moves in the "–"
direction, the image becomes softer. Be sure to view a monitor when the adjustment is
performed.
Note:
• Moire (interference fringes) may be observed when shooting a subject with fine pattern
such as a carpet or a curtain. In such a case, move the indicator in the "-" direction to
reduce moire.
H Pedestal level adjustment [PEDESTAL]
Use the [RIghT] or [LEfT] button to adjust the pedestal level of the camera. When the level
indicator moves in the "+" direction, the image becomes brighter, and when the level indicator
moves in the "–" direction, the image becomes darker. Be sure to view a waveform monitor or a
monitor when the adjustment is performed.
I Chroma phase (hue) adjustment [HUE]
Use the [RIghT] or [LEfT ] button to adjust the pedestal level of the camera. Be sure to view a
vector chromaticity indicator or a monitor when the adjustment is performed.
0
+
23