Camera System Setting [System Setup]; Synchronization Method Selection [Sync]; Privacy Zone Setting [Privacy Zone] - Panasonic WV-CP300 Operating Instructions Manual

Camera system setting [SYSTEM SETUP]

Performs the settings relating to the camera system such as synchronization and privacy zone.
The following settings can be configured on the "SYSTEM SETUP" screen displayed from the
top screen. Refer to page 5-6 for how to call up the screen.
"SYSTEM SETUP" screen
**SYSTEM SETUP**
SYNC
PRIVACY ZONE
STABILIZER
EL-ZOOM
UPSIDE-DOWN
LDC
RET TOP END

@ Synchronization method selection [SYNC]

This unit supports the following 2 types of synchronization methods, and one of the following is selected.
(1) Multiplexed vertical drive signal (VD2)
(2) Internal synchronization (INT) (default)
Input of a multiplexed vertical drive signal (VD2) automatically switches to the VD2
synchronization even if the camera is set to other than the VD2 synchronization method.
When the VD2 synchronization is not selected, internal synchronization can be selected.
A Privacy zone setting [PRIVACY ZONE]
When undesired portions in the camera shooting area (on the screen) exist, those portions (pri-
vacy zone) can be set to be hidden. Up to 8 portions can be specified for the privacy zone.
ON (1): Grays the zone.
ON (2): Mosaics the zone.
OFF (default): Displays the zone normally.
Follow the procedure below to set the privacy zone.
Note:
• The privacy zone function is disabled at initializing the unit, i.e. right after turning on the power.
"SYSTEM SETUP" screen
**SYSTEM SETUP**
SYNC
PRIVACY ZONE
STABILIZER
EL-ZOOM
UPSIDE-DOWN
LDC
RET TOP END
Step 1
Move the cursor to "PRIVACY ZONE", select "ON (1)" or "ON (2)", and press the [SET ] button.
20
INT
OFF
OFF
OFF
OFF
I...... 0
- +
INT
ON(2)
OFF
OFF
OFF
I......0
- +
"ZONE NUMBER" screen
** ZONE NUMBER 1 /8**
POSITION PUSH SET
UPPER LEFT
ZONE LEVEL ..I.... 2
-
DEL
RET TOP END
+