Manual Fine Adjustment Of White Balance - Panasonic WV-CP300 Operating Instructions Manual

Step 1
Set "WHITE BAL" to "AWC" and press the [LEfT ] button to change to "AWC → PUSH SET".
Step 2
Press the [SET ] button and adjust the white balance. "AWC → PUSH SET" is reversely high-
lighted during adjustment. When the reversely highlighted display is restored, the white balance
adjustment is completed.
Step 3
Press the [rIgHT ] button to select "AWC". refer to this page for fine adjustment of the white
balance.
Note:
• The adjustment of the color temperature ranges from approx. 2,000 K to 10,000 K. If the range
is out of this adjustment range or lighting directed to a subject is too dark, the white balance
may not be adjusted. In such a case, "AWC → PUSH SET" stays reversely highlighted.

Manual fine adjustment of white balance

The white balance is manually fine adjusted after white balance automatically adjustment in the
automatic color temperature tracking mode (ATW1, ATW2) or automatic white balance control
mode (AWC).
follow the procedures below.
"CAMERA SETUP" screen
**CAMERA SETUP**
SCENE1
ALC/ELC
SHUTTER
AGC
SENS UP
WHITE BAL
DNR
D&N(IR)
VMD
RET TOP END
Step 1
Set "WHITE BAL" to "ATW1", "ATW2" or "AWC" and press the [SET ] button.
→ The fine adjustment screen appears.
Step 2
Move the cursor to "r" and "B" and use the [LEfT] or [rIgHT ] button to fine adjust the level for
each. "r" stands for red and "B" stands for blue. When the level indicator moves in the "+"
direction, the color becomes deeper, and when the level indicator moves in the "–" direction,
the color becomes lighter.
Step 3
Move the cursor to "ArEA" and press the [SET ] button to enter "ArEA" setting screen.
The area to detect white area of white balance can be set on the area setting screen. The area
to detect white area of white balance is displayed full-screen by default.
To change the white balance detection area, start from step 4.
14
ALC
OFF
ON(HIGH)
OFF
ATW1
HIGH
AUTO1
OFF
Fine adjustment screen
**ATW1**(1)
... I ...
R
- +
... I ...
B
- +
AREA
RET TOP END
Area setting screen
**ATW1 AREA**(1)
0
POSITION
0
RESET
RET TOP END
PUSH SET