Panasonic WV-CP300 Operating Instructions Manual page 16

CP310
CP310
AUTO: Similar to the basic functions of AUTO1, but does not change the IR filter.
CP300
OFF (default): Displays color images.
Note:
• When "AUTO1" or "AUTO2" is selected, it is recommended to set "AGC" to "ON".
CP310
• If a subject is always moving or the screen is occupied with a uniform color, brightness
CP310
determination may not be performed successfully because the brightness is merely deter-
CP300
mined by information from the CCD image sensor. When "AUTO2" is selected, the wave
length of the light source shall be 800 nm or longer.
• WV-CP300 and WV-CP304 cannot set the switching brightness (illuminance) level of color
images and black-and-white images.
• To obtain color images, a sufficient level of illuminance (approx. 30 lx or more) is required.
Step 2
CP310
CP310
Press the [SET ] button.
→ The "D&N (IR)" screen appears.
CP300
Step 3
CP310
CP310
Move the cursor to "LEVEL" and select a brightness level at which switching between color and
black-and-white images is performed from the following.
CP300
LOW: Switches from color to black-and-white images when the ambient brightness (illumi-
nance) of the camera is less than 0.1 lx.
HIGH (default): Switches from color to black-and-white images when the ambient brightness
Note:
• The switching illuminance level varies with subjects, light sources, and lenses.
• The switching illuminance level varies in accordance with AGC setting. (
• The switching illuminances described above are reference values. The switching illumi-
nance shall be decided based on the actual installation environment.
• There may be repeated switching between color and black-and-white images depending
on the setting and environment.
Step 4
CP310
Move the cursor to "DURATION TIME" and select a time for switching between color and
CP310
black-and-white images from the following.
CP300
2 S - 10 S (default) - 30 S - 60 S
(S)
Step 5
CP310
Move the cursor to "BURST (BW)", and decide whether or not to provide a burst signal output
CP310
in the black-and-white mode.
CP300
ON (default): Provides a burst signal output.
OFF: Does not provide any burst signal output.
16
Switches to black-and-white images when brightness (illuminance) around the
camera is lower than approx. 0.1 lx.
(illuminance) of the camera is less than 0.2 lx.
(L)
page 12)
