Recording To A Cassette Tape - Sharp CD-E800W Operation Manual

Recording to a cassette tape

CD-E800W
Before recording:
! When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
! SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
! The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
! For recording, use only normal tapes. Do not use metal or
CrO tapes.
! Recording can be operated in the TAPE 2 compartment. The
TAPE 1 is for playback only.
Erase-prevention tab of cassette tapes:
! When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent accidental
recording or erasing.
! To protect the recorded sound, remove
the tab after recording. Cover the tab
hole with adhesive tape to record on the
tape without the tab.
23
" Recording from a CD (CDs)
You can record 3 CDs continuously.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 2 cassette compartment with
side A facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the CD button and load the desired disc.
4
Press the
one side or both sides.
... To record on both sides.
Side A
... To record on only one side.
5
Press one of the
select the disc to be recorded first.
Tab for Tab for
6
side B side A
Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
7
Press the
[(TAPE-2)
! To record on both sides, begin with side A. (If recording is
started from side B, the tape will not switch over to side A.)
! Recording is started from the selected CD. When the play-
back of the last disc is finished or the end of the tape is
reached, the CD and the cassette will stop automatically.
! CD playback will start approximately 7 seconds after the tape
starts.
To perform programmed recording:
1 Programme discs and tracks. (See page 16.)
2 Press the REC PAUSE (TAPE-2
3 Press the
2) ] button for side B.
To stop recording:
Press the button.
The CD and tape will stop.
03/8/27
button to choose
1 - 3 buttons on the remote control to
( ) button to record on side A, or the
] button for side B.
) button.
( ) button to record on side A, or the
CD-E800W(A)3.fm
TINSE0908AWZZ
[(TAPE-