Recording From The Radio; Erasing Recorded Tapes - Sharp CD-E800W Operation Manual

Note:
Whilst recording, OPEN/CLOSE button is deactivated. It is recom-
mended to perform CD recording after closing the disc tray.
Auto restart function:
If the recording side is switched from side A to B during recording,
the system will record the interrupted track on side B from its begin-
ning. The recording will be made without cutting the beginning of the
track on side B.

" Recording from the radio

1
Tune in to the desired station. (See page 17.)
2
Load a cassette into the TAPE 2 cassette compartment with
side A facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button to choose
one side or both sides.
... To record on both sides.
... To record on only one side.
4
Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
5
Press the ( ) button to record on side A, or the
[(TAPE-2) ] button for side B.
To record on both sides, begin with side A. (If recording is start-
ed from side B, the tape will not switch over to side A.)
To interrupt recording:
Press the REC PAUSE (TAPE-2 ) button.
To resume recording, press the same recording button you pressed
in step 5. Other buttons do not allow resuming.
To stop recording:
Press the button.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
" Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into the TAPE 1 cassette com-
partment. Insert a blank tape into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1 2) button
until "TAPE 1" appears on the
display.
The reverse mode will be set to " ".
4
Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
5
Press the ( ) button to start dubbing.
To stop dubbing:
Press the button.
TAPE 1 and TAPE 2 will simultaneously stop.

" Erasing recorded tapes

1 Load the tape to be erased into the TAPE 2 cassette compart-
ment with the side to be erased facing toward you.
2 Press the TAPE (1 2) button until "TAPE 2" appears on the dis-
play.
3 Set the button to " " to erase only one side and to " " to
erase both sides.
4 Press the REC PAUSE (TAPE-2 ) button.
5 Press the ( ) button to erase side A, or the
button to erase side B.
To erase both sides, begin with side A. (If erasing is started from
side B, the tape will not switch over to side A.)
Note:
Make sure that the TAPE 1 is not in use.
03/8/27 CD-E800W(A)3.fm
CD-E800W
8
[(TAPE-2) ]
24
TINSE0908AWZZ