Timer Operation; Timer Off - Sharp AY-249E-T Operation Manual

TIMER OPERATION

NOTE:
Before setting the timer, make sure the clock is properly set with the current time.
P @ P P P @ P @ P @ P @ @ P P P @ P @ P P @ P @ P @ P @ P @ @ @ @ @ @ P @ P

TIMER OFF

AM
1H
MODE FAN
SWING
SET/C
+
TIPS ABOUT TIMER OFF OPERATION
When the TIMER OFF mode is set, the
temperature setting is automatically adjusted
to prevent the room from becoming
excessively hot or too cold while you sleep.
(Auto Sleep function)
COOL/DRY MODE:
» One hour after the timer operation begins,
the temperature setting rises 1°C higher
than the original thermostat setting.
HEAT MODE:
» One hour after the timer operation begins,
the temperature setting drops 3°C lower
than the original thermostat setting.
NOTES:
» » » » » The Auto Sleep function will not activate
during the FAN ONLY mode.
» » » » » The temperature setting cannot be ad-
justed during the FAN ONLY mode.
1
2
3
1
3
2
-
Press the TIMER OFF (
The TIMER OFF indicator will blink; press the
TIME ADVANCE or REVERSE buttons to set
the desired time. (The time can be set in 10-
minute increments.)
Point the remote control at the signal receiver
window on the unit and press the TIMER SET
(SET/C) button.
» The yellow TIMER lamp (
light.
» The unit will generate a beep when it re-
ceives the signal.
TO CANCEL TIMER MODE
Press the TIMER CANCEL (SET/C) but-
ton.
» The yellow TIMER lamp (
will turn off.
» The current clock time will be displayed
on the remote control.
NOTE:
» If both TIMER ON and TIMER OFF are
set, the TIMER CANCEL button cancels
both settings.
TO CHANGE TIMER SETTING
Cancel the TIMER seting first, then set it
again.
E-9
) button.
) on the unit will
) on the unit
MODE FAN
SWING
SET/C
+ -