Transferring the data on
Card to Computer
Connecting the camcorder to the
computer
Connect the camcorder to the computer
with the supplied USB cable (see page
89).
Transferring data
1
Turn on the computer, then connect
the camcorder with the supplied USB
cable.
2
Set the Media Selection switch to u,
then hold down the Lock button and
set the Power switch to w.
3
Double click the shortcut icon of
PixLab Browser Ver4.
• PixLab Media Browser will start up.
4
Transfer data with PixLab Media
Browser.
• For details about PixLab Media
Browser, refer to the online manual
and help.
Caution on transferring data
While transferring data, the transfer
indicator moves. Do not execute the
operations below.
• Disconnecting the USB cable
• Switching the power on/off
• Turning off the PC or setting it to Standby
• Removing the card
Transfer indicator
U S B
T R A N SM I T T I N G
Note:
• In case of data transfer error, disconnect the
USB cable, then connect it again, or set the
Power switch to OFF, then set it to w again.
Disconnecting the USB
cable
Windows Me/2000/XP
1
Close PixLab Media Browser.
2
Click the "Safely Remove Hardware"
(or "Unplug or Eject Hardware") icon
that appears on the task bar, and
choose an applicable hard drive to
stop.
3
After the message "Safe To Remove
Hardware" appears, disconnect the
USB cable.
Note:
• See Windows Help for the procedure
of disconnecting USB cable in detail.
Windows 98
When data is not being transferred (the
indicator on LCD display stays still), right-
click on the disk drive icon, which appears
on explorer window, to eject the disk. After
that, disconnect the USB cable.
91