Table of Contents
Advertisement
Installing the Battery to
Remote Control
The supplied CR2032 type lithium
battery is used to power the remote
control unit.
1
Insert a pointed object such as the
tip of a ballpoint pen to open the
battery holder.
2
Place the larger lithium battery on
the battery holder with the H side
facing down.
CR2032 type lithium battery
3
Close the battery holder until it
clicks.
Notes on the Use of the Lithium
Battery
CAUTION: Danger of explosion if
battery is incorrectly replaced. For
camcorder, replace only with same or
equivalent type CR1216, for remote
control unit, replace only with same or
equivalent type CR2032, both recom-
mended by the equipment manufac-
turer.
X KEEP THIS BATTERY
AWAY FROM CHILDREN. IF SWAL-
LOWED, CONSULT A PHYSICIAN
IMMEDIATELY FOR EMERGENCY
TREATMENT.
Z BATTERY MAY EXPLODE
IF MISUSED OR INSTALLED WITH
POLARITY REVERSED. DO NOT
RECHARGE, DISASSEMBLE OR
DISPOSE OF IN FIRE.
• Do not short-circuit, recharge, disassemble,
or heat the lithium battery.
• Should the lithium battery leak, wipe the
battery compartment clean, and then insert a
new battery.
• The lithium batteries will last about one year
under normal usage.
13
Advertisement
Table of Contents
