Sleep Mode - Epson PowerLite 745c Manual

Epson PowerLite 745c Projector
Adjusting the Image Shape
The projector automatically corrects images that are distorted
when the projector is tilted up or down (up to a 15° tilt). The
Keystone window appears on the screen while the projector
makes the correction. If the projected image still isn't
rectangular or has a "keystone" shape, do one or more of the
following:
❏ If your image looks like
projector off to one side of the screen, at an angle. Move it
directly in front of the center of the screen, facing the screen
squarely.
❏ If your image looks like
manually adjust the keystone correction value. Follow the
directions below:
❏ To make keystone corrections using the projector's
Setting menu, press the
remote control. Select the
. Select
Enter Keystone
pointer button on the remote control (or the arrow
buttons on the projector) to adjust the keystone setting as
needed.
❏ To manually adjust the keystone correction value, press
the or button on the projector to correct the
shape of the image. After correction, your image will be
slightly smaller.
Adjusting the Brightness
The brightness of an image depends on the source you are
projecting and the amount of light in the room. If the image is
too bright or not bright enough, do one of the following:
❏ Change the
Brightness
❏ Select
or for the
Low High
the Setting menu. Low Brightness mode extends the life of
the lamp and decreases the fan noise.
6 Epson PowerLite 745c Projector
-
or , you've placed the
or , you may need to
button on the projector or
Menu
menu, then press
Setting
and press . Use the
Enter
setting in the Image menu.
option in
Brightness Control
Adjusting the Color Mode
You may want to adjust the color mode to select a setting
that is appropriate for the image you're projecting and the
environment in which you're projecting it.
The following table lists the available color modes.
Color mode Description
For matching the color palette of standard sRGB
sRGB
computer displays.
For increased brightness in bright rooms (the
Dynamic
default for non-computer display).
For computer presentations (the default when
Presentation
projecting from a computer with analog video).
For optimizing movie images with increased
Theater
contrast.
For increased brightness when playing video
Living Room
games or watching TV in a bright room.
For projecting accurate colors on a green
Blackboard
chalkboard (adjusts the white point).
To change the color mode, press the
the remote control until you see the mode you want. The
currently selected setting appears in the upper right corner of
the screen. You can also use the projector menu system to select
the Color Mode in the Image menu.

Sleep Mode

When the projector has not received any input signals for
30 minutes, it automatically turns off the projector lamp and
enters "sleep mode." This conserves electricity, cools the
projector, and extends the life of the lamp. If you are done using
the projector, unplug the power cord. If you want to start
projecting again, press the P
You can enable sleep mode in the Extended menu under
.
Operation
8/04
button on
Color Mode
button.
Power