Epson PowerLite 745c Manual page 14

Epson PowerLite 745c Projector
12. Verify that you've enabled your computer's connection to
the access point. It should be listed as shown above, with
the small icon next to it, indicating a connection.
If it's not listed, click
Configure
your access point.
13. When done, click . Continue with "Projecting
OK
Wirelessly" on page 15.
Checking the Gateway (Access Point's) IP Address
If you're entering IP addresses manually in Access Point mode
and need to find out the gateway IP address (the IP address of
your access point), make sure the wireless connection to the
access point is currently active, as described in the previous
section.
Note:
If you can't identify the gateway address using this Windows
utility, use the administrator's utility software that came with
your access point.
1. Access your wireless network Properties window. For
example, in Windows XP click
Network and Internet Connections
double-click the
Network Connections
2. Right-click the
Wireless Network Connection
select . Then click the
Status
The gateway's (access point's) IP address is listed as shown:
Configuring the Network Settings for Macintosh
Your AirPort software is automatically configured to allow
your Macintosh to detect both computer-to-computer (Ad
Hoc) and Access Point networks.
Typically you only need to select your projector's ESSID (Ad
Hoc) or your AirPort network name (Access Point) on the
Macintosh menu bar. If you're having problems connecting to
the projector, follow these steps:
1. From the Apple pull-down menu, select
.
Preferences
14 Epson PowerLite 745c Projector
-
and then type the name of
Start > Control Panel >
. Then
icon.
icon and
tab.
Support
Gateway
address
System
2. Click the
Network
menu.
Select Automatic
Select Network Port
Configurations
then select AirPort
3. Make sure Location is set to
4. Select
Network Port Configurations
down menu.
5. Under Port Configurations, select
6. Click
Apply Now
7. Ad Hoc mode: Go to step 10.
Access Point mode: Start the AirPort Admin utility. Select
your base station, then click
8. On the AirPort tab, make sure your AirPort network name
matches your projector's ESSID. If not, enter the
projector's ESSID in the AirPort Network text box and
click .
Update
9. If you turned DHCP in your projector's Advanced menu,
click the
Network
checkbox is selected. If you need to select it,
addresses
click .
Update
10. Click the AirPort icon on the menu bar at the top of the
Macintosh desktop. You see the AirPort status menu:
11. Check to make sure AirPort is turned on.
12. Select your projector's ESSID (Ad Hoc) or the name of
your AirPort network (Access Point).
8/04
icon. You see the Network settings
.
Automatic
in the Show pull-
.
AirPort
and close the window.
.
Configure
tab and make sure the
Distribute IP