Using Direct Power On; Shutting Down The Projector; Using The Remote Control - Epson PowerLite 745c Manual

Using Direct Power On

The Direct Power On function enables faster setup. The
projector will start up automatically when you plug it in; you
won't have to press the P
Follow these steps to enable Direct Power On:
1. Press the button on the remote control and select the
Menu
menu.
Extended
2. Choose and press
Operation
3. Choose
Direct Power On
4. Highlight and press
ON
5. Press or to exit.
Esc Menu
Note:
When Direct Power On is enabled, shut down the projector as you
normally would. Follow the instructions in the next section. (The
projector will start automatically when power is restored after a
power failure if it is plugged in.)

Shutting Down the Projector

When you've finished using the projector, follow the
recommended procedure to shut it down. This extends the
lamp life and protects the projector from possible overheating.
1. Turn off any equipment plugged into the projector.
2. To turn off the projector, press the P
projector or remote control. You see a confirmation message.
(If you don't want to turn it off, press any other button.)
3. Press the P button again. The P
Power
orange as the projector cools down. When the projector
beeps twice, it's safe to unplug it.
To turn the projector on again, wait until the P
stops flashing. Then press the P
4. Press up on the blue foot release lever and lower the
projector to retract the front adjustable foot, as shown.
5. Replace the lens cap and unplug the power cord.
button.
Power
.
Enter
and press .
Enter
.
Enter
button on the
Power
light flashes
Power
Power
button.
Power
Caution
To avoid damaging the projector or lamp, never unplug the
power cord when the P

Using the Remote Control

Before using the remote control, insert the two AAA alkaline
batteries, as described on page 8.
When using the remote control, stand within 20 feet of the
projector. Point the remote control either at the projector or at
the screen (the projector's front sensor can detect signals
bounced off the screen). Press the button for the function you
want to use.
Turning Off the Picture and Sound
You can use the
off the image and sound. This is useful if you want to
temporarily redirect your audience's attention.
❏ To turn off the picture and sound, press the
button. The screen turns blue.
❏ To turn the image and sound back on, press the
button again.
You can create an image, such as a company logo or a picture, to
display on the screen whenever you press the
See the User's Guide for more information.
Stopping Action
Press the
Freeze
computer image and keep the current image on the screen. The
sound will continue.
To restart the action, press the
press .
Esc
light
Zooming Your Image
Follow these steps to zoom in on a portion of the image:
1. Press the
E-Zoom
a crosshair indicating the center of the zoom-in area.
2. Use the
area you want to enlarge.
3. Continue pressing the
selected area up to 4 times.
8/04
Epson PowerLite 745c Projector
light is green or flashing orange.
Power
button on the remote control to turn
A/V Mute
button to stop the action in your video or
button again or
Freeze
button on the remote control. You see
pointer button to position the crosshair in the
button to enlarge the
E-Zoom
Epson PowerLite 745c Projector
A/V Mute
A/V Mute
button.
A/V Mute
7
-