Epson PowerLite 745c Manual page 17

3. Click
Use IP connect mode
screen:
4. Click . You see this screen:
IP connection
5. Enter the projector's IP address and click
The IP address appears in the Projector list and a
searching icon displays.
Indicates
search in
progress
If the search fails to find a projector with the specified IP
address, the searching icon turns into a question mark.
If this happens, run EasyMP to check the projector's IP
address, then repeat this step.
, then click . You see this
OK
.
Search
Epson PowerLite 745c Projector
Note:
If you still don't see the projector, make sure the Internet
Connection Firewall is disabled.
6. Click the projector you want to connect to, then click the
button. If more than one projector is listed, you
Connect
can select additional projectors and connect to them at the
same time.
7. If you are prompted for a keyword, enter the four-digit
number displayed on the EasyMP Network screen and
click .
OK
Removing the Wireless 802.11G/B Card
Follow these steps to remove the card from your projector.
1. If you're running NS Connection, click
control bar.
2. Check the card access light to make sure it isn't flashing.
Caution:
Never remove the card while the card access light is green or
flashing. You may damage the card or lose data.
3. Press the eject button. The button pops out.
Eject button
Access light
4. Press the eject button again. The wireless card partially
ejects.
5. Pull the card straight out. Then press the eject button back
in to prevent it from being damaged.
8/04
Disconnect
Click here
Epson PowerLite 745c Projector
on the
17
-