Hold Function - Sharp MD-MT190H Operation Manual

Playback (continued)
MD-MT190H
ENGLISH


Bass control
Each time the BASS button is pressed, the tone will be
switched as follows.
BASS 1 Emphasised slightly.
BASS 2 Emphasised more.
BASS 3 Emphasised fully.
BASS OFF Cancelled.

Hold Function

The present operation condition can be kept even if other
buttons are accidentally pressed in a place such as a
crowded train.
Main unit
Press the HOLD button for 2 seconds or more.
Hold
If the battery is inserted or the AC adaptor is connected, you
can set this function even when the power is turned off.
To cancel the hold mode
Press and hold down the HOLD button for 2 seconds or more
whilst the unit is in the hold mode.
E-15
Notes:


You cannot change the bass setting whilst selecting
menus.


Reduce the volume before starting to play. MiniDiscs,
compared to ordinary cassette tapes, have very little
noise. If the volume is adjusted according to your usual
expectations of noise, high volume may damage your
hearing.


The sound escaping from your earphones may annoy
people around you. In particularly crowded places (such
as on trains or buses), reduce the volume.
Remote control unit
Move the HOLD switch to the safety position
(direction indicated by the arrow).
Release
To cancel the hold mode
Move the HOLD switch away from the safety position (the
opposite direction of the arrow).
If the hold function is active whilst the power is turned off,
the power cannot be turned on by mistake and the battery
will not be drained.
01/10/29
Orange mark
Hold
MD-MT190H(SEEG)_3.fm