Sharp MD-MT190H Operation Manual page 32

Recording from a Microphone (continued)
MD-MT190H
ENGLISH


Sound-actuated recording (Mic Synchro-
nised recording)
1
Press the REC button.
2
Press the REC LEVEL
the recording level.
3
Select the recording mode (steps 5 - 8, page 12).
4
Press the ENTER/SYNC button to select the record-
ing sensitivity.
MIC SYNC H: Recording starts when the unit de-
tects -24 dB or more (the unit can start
recording from quiet sounds).
MIC SYNC L: Recording starts when the unit de-
tects -12 dB or more.
5
When a sound, such as person speaking, is picked
up by the microphone, recording will begin auto-
matically.
E-25
About pause function
The unit automatically pauses when the microphone
does not pick up any sound for 3 seconds or more.
(Pause function does not work for approximately 10 sec-
onds after a recording starts.) When the microphone
picks up sound again, recording starts automatically.
or button to adjust Notes:


Whilst making a mic recording, do not connect any-
thing to the OPTICAL/LINE IN socket on the portable
MD.


To use a microphone, be sure it is a plug-in-power
type microphone.
- When a plug-in-power type microphone is plugged in,
the portable MD will provide power for the micro-
phone's operation.
- If a different type of microphone is plugged in, it may
not operate properly or it may cause the unit to mal-
function.


Insert the plug firmly. If you don't, the recording will not
be made properly.


Use a microphone with a 3.5 mm (1/8") diameter ste-
reo mini plug.


If the unit starts recording too often from low unwanted
noises, set the microphone input to "MIC SYNC L".


Recording sensitivity can be changed whilst recording.
01/10/29 MD-MT190H(SEEG)_4.fm