Sharp MD-MT170E Operation Manual page 30

Titling a MiniDisc (continued)
MD-MT170E


To add characters
1
Put the unit in the character input mode.
(Perform steps 1 - 4 on page 29.)
2
Press the VOL+ or VOL- button to move the
cursor to the character before which you
want to add a new character.
3
Select the character to add.
(Perform steps 5 - 7 on page 29.)
4
Press the MENU/CHRG button.


"TOC" will be displayed. To write the updated con-
tents to the MiniDisc, press the :OFF/HOLD but-
ton.


You cannot remove the MiniDisc whilst "TOC" is
displayed. "TOC" will not disappear until the re-
corded contents have been updated.


To erase a character
Press the VOL+ or VOL- button to move the cursor to the
character you want to erase, and then press the BASS
button.
30


To enter a space
Press the VOL+ button to move the cursor to the right.
Space
Note:
One disc name and up to 255 track names can be cre-
ated per disc (a maximum of 100 characters for the disc
and each track name and a total of 1,700 characters can
be entered. However, if any tracks are recorded in the 2
times or 4 times long recording mode, the number of
characters to be entered is decreased, since the informa-
tion of the recording mode is stored by the track).


Characters (symbols)
Capital letters
A B C D E F G H I J K L M
. ,
S T U V W X Y Z /
Lower-case letters
a b c d e f g h i j k l m
s t u v w x y z . , /
Numbers and symbols
1 2 3 4 5 6 7 8 9 0 ! " #
) + , . / : ; < = > ? @
*
indicates a space.
01/10/26 MD-MT170E_5.fm
N O P Q R
n o p q r
$ % & ' (
_
`