Aerial Connection - Sharp XL-HP500W Operation Manual

! Aerial connection

Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS terminal and posi-
tion the FM aerial wire in the direction where the strongest signal
can be received.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM LOOP socket. Position the
AM loop aerial for optimum reception. Place the AM loop aerial on a
shelf, etc., or attach it to a stand or a wall with screws (not supplied).
Note:
Placing the aerial on the unit or near the AC power lead may cause
noise pickup. Place the aerial away from the unit for better recep-
tion.
Installing the AM loop aerial:
< Assembling > < Attaching to the wall >
Wall Screws (not supplied)
External FM aerial:
Use an external FM aerial if you require better reception. Consult
your dealer.
External
FM aerial
75 ohm
coaxial
cable
Note:
When an external FM aerial is used, disconnect the supplied FM
aerial wire.
! Speaker connection
Connect the black wire to the minus (-) terminal, and the red wire to
the plus (+) terminal.
Caution:
" Connect the speaker wires to the speakers first, then to the
unit.
" Use speakers with an impedance of 6 ohms or more, as lower
impedance speakers can damage the unit.
" Do not mistake the right and the left channels. The right speaker
is the one on the right side when you face the unit.
" Do not let the bare speaker wires touch each other.
" Do not allow any objects to fall into or to be placed in the bass
reflex ducts.
" Do not stand or sit on the speakers. You may be injured.
Incorrect
Speaker grilles are removable:
Make sure nothing comes into contact
with the speaker diaphragms when you
remove the speaker grilles.
02/8/6 XL-HP500W(A)1.fm
XL-HP500W
ENGLISH
Incorrect
E-8