Erasing Recorded Tapes - Sharp XL-HP500W Operation Manual

Hide thumbs

Table Of Contents

Table of Contents

Recording from several CDs continuously:

1 Perform steps 1 - 5 in "Recording from a CD (CDs)" on page 23.

2 Press the

( ) button to record on side A, or the

side B.

To perform programmed recording:

1 Programme discs and tracks. (See page 17.)

2 Press the

button.

3 Press the

( ) button to record on side A, or the

side B.

To stop recording:

Press the

(TAPE ) button.

The CD and tape will stop.

Auto restart function:

If the recording side is switched from side A to B during recording,

the system will record the interrupted track on side B from its begin-

ning. The recording will be made without cutting the beginning of the

track on side B.

Erase-prevention tab of cassette tapes:

! When recording on a cassette tape,

make sure that the erase-prevention

tabs are not removed. Cassettes have

removable tabs that prevent accidental

recording or erasing.

! To protect the recorded sound, remove

the tab after recording. Cover the tab

hole with adhesive tape to record on the

tape without the tab.

" Recording from the radio

Tune in to the desired station. (See page 18.)

button for

Load a cassette into the cassette compartment with side A

facing you.

Wind past the leader of the tape, on which recording cannot be

performed.

button for

Press the

... To record on both sides.

... To record on only one

side.

Press the

Recording will be paused.

Press the

ton for side B.

To record on both sides, begin on side A. (If recording is started

from side B, the tape will not switch over to side A.)

Side A

To interrupt recording:

Press the

button.

To resume recording, press the same recording button you pressed

Tab for

in step 5. Other buttons do not allow resuming.

side B

side A

To stop recording:

Press the

(TAPE ) button.

Note:

If you hear a whistling noise whilst recording an AM station, move

the AM loop aerial.