Sharp XL-HP500W Operation Manual page 10

System connections (continued)
XL-HP500W
ENGLISH
230V
240V
E-9
! Setting the AC voltage selector
Check the setting of the AC voltage selector located on the rear
panel before plugging the unit into a wall socket. If necessary, adjust
the selector to correspond to the AC power voltage used in your
area.
Turn the selector with a screwdriver until the appropriate volt-
age number appears in the window (110 V, 127 V, 220 V or 230
V - 240 V AC).
! Connecting the AC power lead
After checking all the connections have been made correctly, plug
the AC power lead of this unit into the wall socket. If you plug the
unit first, the unit will enter the demonstration mode (see page 10).
Notes:
Wall socket
" The unit will start the tape initialisation when plugged in to the AC
socket. During this process, initialising sound will be heard and
the unit cannot be turned on. Wait until the process is finished.
" Unplug the AC power lead from the wall socket if the unit will not
be in use for a prolonged period of time.
(230 - 240 V, 50/60 Hz)
02/8/6 XL-HP500W(A)1.fm