Listening To A Cd (Cds); Disc Trays; Cd Eject Buttons; Cd Or Tape Stop Button - Sharp XL-HP500W Operation Manual

Listening to a CD (CDs)

This system can also play audio CD-R and CD-RW discs, but can-
not record.
Some audio CD-R and CD-RW discs may not be playable due to the
state of disc or the device that was used for recording.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button.
3
Press the button to open the disc tray 1.
4
Place the CD on the disc tray 1, label side up.
Be sure to place 8 cm (3") CD in the middle of the disc trays.
12 cm (5")
5
Press the button to close the disc tray 1.
Total number of tracks on
the CD whose number is
flashing
6
You can place discs on the trays 2 - 3 by following steps
3 - 5.
7
Press the /
" Playback will begin from track 1 on the DISC 1. After that
disc finishes playing, the next disc will automatically play.
" When the last track on the third disc has finished playing,
the CD player will stop automatically.
" When there is no CD in one of the disc tray 1 - 3 positions,
that position will be skipped and the next CD will be played.
To interrupt playback:
Press the CD button on the remote control.
To resume playback from the same point, press the
To stop playback:
Press the (CD ) button.
To exchange other CDs whilst playing a disc:
Press the button for the stopped disc and exchange discs.
To remove the CDs:
8 cm (3")
Whilst in the stop mode, press the desired
02/8/6
Total playing time of the
CD whose number is
flashing
button to start playback.
button.
button.
XL-HP500W(A)2.fm
XL-HP500W
ENGLISH
E-14