Speaker Connection - Sharp XL-DK227NH Operation Manual

Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and position
the FM aerial wire in the direction where the strongest signal can be
received.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM and GND (Earth) terminals.
Position the AM loop aerial for optimum reception. Place the AM loop
aerial on a shelf, etc., or attach it to a stand or a wall with screws (not
supplied).
Note:
Placing the aerial on the unit or near the AC power lead may cause
noise pickup. Place the aerial away from the unit for better reception.
Installing the AM loop aerial:
< Assembling > < Attaching to the wall >
Wall Screws (not supplied)

Speaker connection

Connect the black wire to the minus (–) terminal, and the red wire to
the plus (+) terminal.
Caution:
Use speakers with an impedance of 4 ohms or more, as lower
impedance speakers can damage the unit.
Do not mistake the right and the left
channels. The right speaker is the one on the
right side when you face the unit.
Do not let the bare speaker wires touch
each other.
Do not allow any objects to fall into or to be
placed in the bass reflex ducts.
Do not stand or sit on the speakers. You may
be injured.
Connecting iPod to a TV
The iPod with photo and video can be viewed by connecting to a TV/
monitor.
If the TV/monitor has a video input, connect it to the VIDEO OUT socket
on the rear of the unit.
Video cable
(not supplied)
Note:
Please make sure to set iPod unit to either NTSC or PAL to match your
TV signal. Please visit Apple's home page for further information.
Red Black
Incorrect
TV
To video
input socket
XL-DK227NH
XL-DK257NH
8