Table of Contents
Advertisement
Indicator Status
Blinking in
Warm-up in
Green
progress
Illuminated in
Internal error
Red
Extinguished
The power is not
switched on
Lamp Indicator
Indicator Status
Blinking in Red
Lamp error
Blinking in
Nearing the time
Orange
for replacing the
lamp
Extinguished
Cause
(Not an error)
· Wait for a moment.
· The amount of time required for the warm-up
procedure is approximately 30 seconds.
· The green lamp will stop blinking and
become illuminated once the warm-up
procedure has been completed.
Cease operations, remove the Power Plug from
the socket and contact your dealer or nearest
address provided at page 107 and request
repairs.
The power is not switched on.
· Check the power cord connection.
· Check the power supply to the socket.
Cause
· Replace with a new lamp (ELPLP11).
· If the lamp is broken, take care to avoid injury
and contact your nearest address provided at
page 107 to request repairs (images cannot be
projected unless the lamp is replaced).
· Check to ensure that the lamp or fan are
correctly attached if the lamp has been
replaced. If the lamp or fan are not correctly
attached, the projector will assume the same
status as if the power has not been switched
on.
Prepare a new lamp. It is recommended that
the lamp is replaced as soon as possible, as
there are cases where the time for replacement
is earlier than stated in the conditions of usage.
(Not an error)
The power has not been switched on or nor-
mal projection is in progress.
Recovery or Status
Recovery and Status
Reference
Page
42
42
Reference
Page
97
97
Troubleshooting - 85
Advertisement
Table of Contents
