Refl Ective Panel Installation - Regency Horizon HZ30E-NG Owners & Installation Manual

INSTALLATION
Before installation, panels must be handled and cleaned as per instructions noted below:
Stainless Steel Panels
•
Stainless panels must be inspected for scratches and dimples prior
to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
•
To protect the fi nish during installation and handling - cotton
gloves MUST be worn at all times while handling the panels (even when
removing protective coating).
•
Use a hair dryer to remove the protective coating from the panels.
•
Stainless panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
All hand and fi nger marks MUST be cleaned off with a soft cloth and
*
a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner
(ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this will result in burn stains on panels which you
will be unable to remove. Not protected by product warranty.
1) Remove the faceplate and glass door if already installed - see
manual for instructions.
2) Install the back panel fi rst. Tilt the panel forward - position the bottom
of the panel fi rst. Use care not to scratch or mar the panel on the
pilot shield.
3) Install the left side panel - secure in position with one panel clip and
one screw, as shown in the diagram below.
46
REFLECTIVE PANEL INSTALLATION
Black Enamel Panels
•
Black Enamel panels must be inspected for scratches and dimples
prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
•
Black Enamel panels will discolor a little during normal operation. This
is normal and should not be considered a defect.
All hand and fi nger marks MUST be cleaned off with a soft cloth. Use
*
an ammonia based cleaner (ie. glass cleaner) to remove any fi ngerprints
before applying heat to the unit.
Failure to do this will result in burn stain on panels which you
will be unable to remove. Not protected by product warranty.
4) Install the right side panel - secure in position with one panel clip
and one screw.
5) Reinstall glass door - reinstall faceplate.
6) Final installation
Regency Horizon™ HZ30E Gas Fireplace