Regency Horizon HZ54E-NG Owners & Installation Manual page 43

9) Install 4 - AA batteries into the receiver.
10) Plug 'motor' wires into the back of the receiver and bundle wires with the
wire clip - as shown below.
11) Install the heat shield to the receiver with two screws and attach to the
fl oor of the unit with a velcro pad.
Regency Horizon HZ54E Gas Fireplace
12 Before installing the fan control module, install the heat shield on the
control module by securing with 2 screws.
13) From the wire harness, plug the FCM wire into the fan control modul
14) Install the fan control module onto the velcro pad located on the fl oor
the unit located left of the receiver.
15) Plug fan control module into receptacle located on the left hand side of
unit.
16) Match the remote control to the receiver - see remote control
instructions.
Heat shield
17) Reverse step 1.
18) Check to ensure there are no gas leaks..
INSTALLATION
Fan Control Module
FCM wire
43