Faceplate Installation - Regency Horizon HZ42ST-NG Owners & Installation Manual

INSTALLATION
1) Hook the fl ange on the back of the faceplate over the top edge of
the glass door - as shown below.
Faceplate
2) The height at which the faceplate sits may be adjusted to maintain
an even space between the upper faceplate and
lower faceplate panel.
The upper faceplate can be raised up once the
lower faceplate panel is in position - by adjusting the 2 screws
at the back of the upper faceplate - see below
(requires an extended phillips head screw driver)
40

FACEPLATE INSTALLATION

The bottom panel of the faceplate installs on the unit with 2 slides.
These slides are located in the bottom of the unit - already installed
within the outer slide. The inner slides need to be removed to install
them on the brackets.
3) Pull out inner slide from the outer slide.
4) Push done on the black lever on the outside of the inner slide - this will
release the inner slide. Pull inner slide out - from outer slide.
Glass Door
5) Install the fi rst inner slide to the faceplate bracket with 2 screws as
shown below.
Note: Brackets are shipped with the unit - not the faceplate.
6) Position the faceplate bracket and slide under the
mounting plate.
The mounting plate is located on the inside lower
edge of the faceplate panel.
Mounting Plate on Faceplate
Backside of Faceplate Panel
HZ42ST Regency Horizon
Inner Slide
Bracket
Inner Slide
TM Gas Fireplace