Brother MFC-J4510DW Quick Setup Manual page 24

Wired Network
For wired network interface users
17
Before you install
Make sure your machine is connected to the power
and your Macintosh is ON. You must be logged on
with Administrator rights.
NOTE
• For Mac OS X v10.5.0 to 10.5.7 users, upgrade
to Mac OS X v10.5.8 - 10.7.x.
• If you have previously set up your machine for
a wireless network and then want to set it up on
a wired network, you should check that the
machine's Network I/F is set to
Wired LAN. The wireless network interface
will become inactive with this setting.
On your machine, press
Press All Settings.
Press Network.
Swipe up or down, or press a or b to display
Network I/F, and then press
Network I/F.
Press Wired LAN.
Press .
24
(Mac OS X v10.5.8, 10.6.x, 10.7.x)
.
18
Connect the network
cable
a
Lift the scanner cover until it locks securely into
the open position.
b
You will find the Ethernet port marked with a
symbol inside the machine on the left as
shown below. Remove the orange protective
cap and connect the network cable to the
Ethernet port.
Macintosh