Table of Contents
Advertisement
Problem Solving
Status
Auto Iris Error
Power Err. (Ballast)
Indicator is flashing or lit orange
m o
Status
High Temp Warning
Replace Lamp
• If the projector is not operating properly, even though the indicators are all showing normal, refer to "When the Indicators Provide No Help" p.58.
q
• If the error is not indicated in this table, stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or
the nearest address provided in the Support and Service Guide. s
Cause
If it is cracked: Replace it with a new lamp, or contact your local dealer for further advice. If replacing the lamp yourself, be
careful to avoid pieces of broken glass (you cannot continue projecting until the Lamp is replaced). s
List
Check that the lamp cover and lamp are securely installed. s
If the lamp cover or the lamp are not installed correctly, the lamp does not turn on.
When using at an altitude of 1500 m or more, set High Altitude Mode to On. s
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address
provided in the Support and Service Guide. s
Cause
(This is not an abnormality. However, if the temperature rises too high again, projection stops automatically.)
• Check that the air filter and Air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s p.67,
Replace it with a new Lamp. s
If you continue to use the Lamp after the replacement period has passed, the possibility that the lamp may explode increases.
Replace it with a new Lamp as soon as possible.
Remedy or Status
p.69
Epson Projector Contact List
: Lit
: Flashing
Remedy or Status
p.72
p.69
Epson Projector Contact List
Epson Projector Contact
p.39
: Off
: Varies according to the projector status
57
Advertisement
Table of Contents
