Table of Contents
Advertisement
Security Functions
Procedure
A
During projection, hold down the [Freeze] button for about
five seconds.
The Password Protect setting menu is displayed.
Remote Control
• If Password Protect is already activated, you must enter the
q
Password.
If the Password is entered correctly, the Password Protect setting
menu is displayed. s "Entering the Password"
• When the Password is set, stick the Password protect sticker in a
visible position on the projector as a further theft deterrent.
B
Turn on Power On Protect.
(1)
Select Power On Protect, and then press the [Enter] button.
(2)
Select On, and then press the [Enter] button.
(3)
Press the [Return] button.
C
Turn on User's Logo Protect.
(1)
Select User's Logo Protect, and then press the [Enter] button.
(2)
Select On, and then press the [Enter] button.
(3)
Press the [Return] button.
D
Turn on Network Protect.(EB-826W/825/85/84 only)
E
Set the Password.
p.30
Entering the Password
When the Password entry screen is displayed, enter the Password using
the numeric buttons on the Remote Control.
(1)
Select Network Protect, and then press the [Enter] button.
(2)
Select On, and then press the [Enter] button.
(3)
Press the [Return] button.
(1)
Select Password, and then press the [Enter] button.
(2)
The message Change the password? is displayed, select Yes and then
press the [Enter] button. The default setting for the Password is "0000".
Change this to your own desired Password. If you select No, the screen
shown in step 1 is displayed again.
(3)
While holding down the [Num] button, enter a four digit number using
the numeric buttons. The number entered is displayed as "* * * *". When
you enter the fourth digit, the confirmation screen is displayed.
Remote Control
(4)
Re-enter the Password.
The message Password accepted. is displayed.
If you enter the Password incorrectly, a message is displayed prompting
you to re-enter the password.
30
Advertisement
Table of Contents
