Using Emp Monitor; Opening And Closing Emp Monitor - Epson 822p/83c User Manual

note
If you want to monitor the
projector while it is in
standby mode, select
in the
Standby Mode
Extended menu, then select
. See page 58.
Network On
Monitoring the Projector Over a Network
94
4. When you're done, press
When a problem occurs, an e-mail message is sent to the specified
addresses with the subject line
information:
Line 1: The name of the projector where the problem has
■
occurred
Line 2: The IP address of the projector where the problem has
■
occurred
■ Line 3: Details of the problem

Using EMP Monitor

EMP Monitor lets you use a remote computer to manage your
projectors. It lets you easily turn the projector on or off, switch image
sources, and check its status.
Before using EMP Monitor, make sure you've installed the software
(available for Windows only) as described on page 90. The computer
you're using to monitor the projector should already be connected to
your network.

Opening and Closing EMP Monitor

To start EMP Monitor, click
EPSON Projector > EMP Monitor
If you've added the program to the Startup programs folder, then it
may already be open. If so, click the icon in the system tray on the
lower-right corner of your screen to display the EMP Monitor
window:
To close EMP Monitor, select
the program icon shown above, then select
to exit the menu system.
Menu
and the following
EPSON Projector
or
Start > Programs All Programs >
.
Click here to start EMP Monitor
from the File menu or right-click
Exit
.
Exit