Table of Contents
Advertisement
Projecting
40
Adjusting the Image Shape
If the projector is tilted up or down, the images that are displayed will
be distorted. To correct the distortion or "keystone" shape, do one or
more of the following:
If your image looks like
■
off to one side of the screen, at an angle. Move it directly in front
of the center of the screen, facing the screen squarely.
■
If your image looks like
keystone correction value. Press the
projector to correct the shape of the image. After correction, your
image will be slightly smaller.
■
You may need to turn on Auto Keystone. See page 56 for
instructions.
You can also make keystone adjustments using the projector's Settings
menu. See page 56.
Adjusting the Brightness
The brightness of an image depends on the source you are projecting
and the amount of light in the room. If the image is too bright or not
bright enough, here are two ways you can adjust it:
■
Change the
Brightness
Select
or
■
Low
High
Settings menu. (See page 57.) Low brightness mode extends the
life of the lamp and decreases the fan noise.
or
, you've placed the projector
or
, you need to adjust the
or
setting in the Image menu. See page 53.
for the
Brightness Control
buttons on the
option in the
Advertisement
Table of Contents
