Problem Solving; What To Do When The Lights Come On Or Flash - Epson 810 User Manual

Problem Solving

This section explains how to interpret the projector's status lights, solve problems with the
picture and remote control, and contact technical support.
What To Do When the Lights Come On
or Flash
The lights on top of the projector indicate the projector's
status and let you know when a problem occurs.
If the projector isn't working correctly, first press the
button or the
Power
P
control, let it cool down, turn off the power switch on the
back, and unplug it. Then plug the power cord back in
and turn on the projector. If this doesn't solve the
problem, check the status lights on top of the projector.
Light state
P Power light does not come
on
P Power light is orange
P Power light is flashing
green
P Power light is flashing
orange and you can't turn the
projector on or off
Warning light is
flashing orange
button on the remote
Off
Cause and solution
Make sure the power switch on the back of the projector is
turned on and the power cord is connected securely at both ends.
The projector is in standby mode. Turn off the power switch in
back to turn off the projector, or press the
turn it on.
The projector is warming up. Wait for the picture to appear.
The projector is cooling down. Wait until the light stops flashing
and shines orange. Then turn off the power switch in back to turn
off the projector, or press the
High-speed cooling is in progress. If the projector gets too hot
again, projection stops automatically. Make sure there is plenty of
space around and under the projector for ventilation. Clean or
replace the air filter if necessary (see page 48).
Power light
Warning light
P
Power button to
P
Power button to turn it on.
Problem Solving
55