Epson 810 User Manual page 17

You will need the optional projector mount designed for the projector. See page 11 for
ordering information.
Warning: When installing or adjusting the ceiling mount, do not use adhesives to prevent the
screws from loosening and do not use any type of oil or lubricant. These may cause the projector
casing to crack and the projector may fall, causing serious injury and serious damage to the
projector.
Follow the instructions included with the mount to install the projector, which weighs
11.5 pounds. The wall or ceiling where you install it must be capable of supporting a weight
of 58 pounds.
In addition to the tools supplied with the projector mount, you will need a Phillips head
screwdriver and a drill to use on the wall or ceiling.
If you install the projector on the ceiling, you will need to
invert the picture so that it appears right side up. Follow
these steps:
1. Press the button on the remote control.
Menu
2. Press the menu navigation buttons to open the
menu, then select
Settings
3. Use the navigation buttons to select
4. Press the button when done.
Menu
If you are planning to use an AV controller with the projector,
refer to the table of ESC/VP21 command codes on page 65.
.
Projection
Front/Ceiling
Menu
button
Menu
navigation
.
buttons
Setting Up the Projector
17