Cleaning The Projector Case; Cleaning And Replacing The Air Filter - Epson 810 User Manual

Cleaning the Projector Case

Before you clean the case, turn off the projector and unplug the power cord.
■
To remove dirt or dust, wipe the case
with a soft, dry, lint-free cloth.
■
To remove stubborn dirt or stains,
moisten a soft cloth with water and a
neutral detergent. Then wipe the case and
dry it with a dry cloth.
Caution: Never use wax, alcohol, benzene,
thinner, or other chemical detergents. These can damage the case.

Cleaning and Replacing the Air Filter

Your projector includes an air filter to ensure the best performance. If dust collects on the air
filter on the bottom of the projector, clean it as described below. Dust clogs prevent proper
ventilation and cause overheating and damage to the projector.
1. Press the P
cools down.
2. Turn off the projector using the power switch on the back.
3. Unplug the power cord and disconnect any cables.
4. Use a small vacuum cleaner that is designed for computers
and other office equipment to clean the filter on the
bottom of the projector, as shown. If you don't have one,
gently clean the filter using a very soft brush (such as a
clean artist's paintbrush).
If the dirt is difficult to remove or the filter is broken,
replace it. Purchase air filter part number V13H134A09
from an authorized Epson reseller. To find the nearest
reseller, please call 800-GO-EPSON (800-463-7766). To
purchase online, visit www.epsonstore.com (U.S. sales) or
www.epson.ca (Canadian sales).
48
Maintenance
button and wait for the P power light to stop flashing. The projector
Power