Advertisement
INSTALLING
BATTERY
PACK
See Figure6.
NOTE: Battery pack is shippedin a low chargecondition,
Therefore, it must be charged priorto use. Refer to page
14, "CHARGING THE BA'rrERY PACK" for charging
instructions.
• Place battery pack in the saw. Align raised rib on bat-
tery pack with groove inside saw, then slide battery
pack in saw as shown in figure 6.
• Make sure the latches on each side of the battery pack
snap into place and battery pack is secured in saw
before beginning operation.
CAUTION; When placing battery pack in the saw,
be sure raised rib on battery pack aligns with groove
inside saw and latches snap into place properly.
Improper assembly can cause damage to saw and
battery pack.
REMOVING BATTERY PACK
See Figure 7.
• Locate latches on side of battery pack and depressto
release battery pack from the saw.
• Remove battery pack from the saw.
DEPRESS LATCHES T O
TO
REMOVE
TO
INSTALL
LATCHES
BATTERY P ACK
Fig. 7
LATCHES
BATTERY P ACK
Fig. 6
16
Advertisement
