Advertisement
BEVEL CUTTING
See Figures 22 - 24.
NOTE; Refer to "Using the Laser Guide" on page 19 for
the following aplications
To make the best possible cut, follow these helpful hints:
• Align the line of cut with the inner blade guide notch on
the base when making 45° bevel cuts.
• Make a trial cut in scrap material along a guideline to
determine how much you should offset the guideline
on the cutting material.
• Adjust the angle of the cut to any desired setting be-
tween zero and 51.5°. Refer to "To Adjust Bevel
Setting" next.
NOTE: When making bevel cuts, you may need to
re-adjust laser (See "Adjusting the Laser.")
TO ADJUST BEVEL SETTING
See Figure 23.
• Remove battery pack from the trim saw.
• Loosen bevel adjustment knob.
• Raise motor housing end of saw until you reach de-
sired angle setting on bevel scale.
• Tighten bevel adjustment knob securely.
WARNING: Attempting a bevel cut without having
the bevel adjustment knob securely tightened can
result in serious injury.
TO BEVEL CUT
See Figure 24.
• Hold the saw firmly with both hands as shown.
• Rest the front edge of the base on the workpiece.
• Start the saw and let the blade reach full speed.
• Guide the saw into the workpiece and make the cut.
• Release the trigger and allow the blade to come to a
complete stop.
•
Lift the saw from the workpiece.
BEVEL
SCALE
BEVEL
ADJUSTMENT
KNOB
BLADE GUIDE
NOTCH
Fig. 22
BEVEL
ADJUSTMENT KNOB
II
\7
.
,CA,E/
0°=.<. II,?fJJttl/j
/
GUIDEUNE
ALIGN INNER BLADE GUIDENOTCH ONSAWBASE WITH
LINEOFCUTASSHOWN WHENMAKING 45° BEVEL CUTS
Fig. 23
Fig. 24
22
Advertisement
