Advertisement
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot bat-
tery pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger, If the green LED continues
to remain on, return battery pack to your nearest Sears
Repair Center for checking or replacing.
BArrERYPACK
SHOWN IN CHARGER
CHARGER
NOTE: This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to "CHARG-
ING A COOL BATTERY PACK" for normal recharging
of batteries. If the charger does not charge your battery
pack under normal circumstances, return both the battery
pack and charger to your nearest Sears Repair Center for
electrical check.
REDLEDONINDICATES
GREEN LEDONAFTER FAST CHARGING
CYCLE, I NDICATES F ULLY CHARGED
BATTERY P ACK ANDIN TRICKLE
CHARGE MODE,
4-1/2 in
YELLOW ANDGREEN LEDS ONINDICATES DEEPLY
DISCHARGED ORDEFECTIVE B ATTERY P ACK.
Fig. 5
15
Advertisement
