Advertisement
POSITIVE
0 ° BEVEL STOP
See Figure25.
The saw has a positive 0° bevel stop that has been factory
adjusted to assure0 ° angleof the saw blade when making
90° cuts.
TO CHECK POSITIVE 0° BEVEL STOP
• Remove battery pack from the trim saw.
• Place the saw in an upside down position on a work-
bench.
• Check the squareness of the saw blade to the base of
the saw using a carpenter's square.
TO ADJUST POSITIVE 0° BEVEL STOP
Fo(Iowthese directionsto adjustthe positive 0° bevel
stop:
• Remove battery pack from the trim saw.
• Loosen bevel adjustment_knob.
• Turn setscrew with hex key and adjust base until it is
square with the saw blade.
• Tighten bevel adjustment knob securely.
_lb WARNING: Attempting a bevel cut without having
the bevel adjustmentknob securely tightened can
resultin serious injury.
ADJUSTMENT
SCREW
\
HEXNUT
POSITIVE 0°
BEVEL STOP
CARPENTER'S
SQUARE
BEVEL
ADJUSTMENT
KNOB
BLADE
Fig. 25
23
Advertisement
