ATTACHING BLADE
SeeFigure2.
P,
WARNING: A 5-1/2 in. blade is the maximum blade
capacity of the saw. Never use a blade that is too
thick to allow outer blade washer to engage with the
flats on the spindle. Larger blades will come in con-
tact with the blade guard, while thicker blades will
prevent blade screw from securing blade on spindle.
Either of these situations could result in a serious ac-
cident.
•
Locate latches on side of battery pack and depress to
release battery pack from the saw.
•
Remove blade wrench (5 mm hex key) from storage
area.
•
Depress spindle lock button and remove blade screw
and outer blade washer.
NOTE: Turn blade screw clockwise to remove.
• Wipe a drop of oil onto inner blade washer and outer
blade washer where they contact blade.
,&
AI& WARNING: If inner blade washer has been re-
moved, replace it before placing blade on spindle.
Failure to do so could cause an accident since blade
will not tighten properly.
• Fit saw blade inside lower blade guard and onto
spindle.
NOTE: The saw teeth point upward at the front of saw
as shown in figure 2.
• Replace outer blade washer.
•
Depress spindle lock button, then replace blade screw.
Tighten blade screw securely.
NOTE: Turn blade screw counterclockwise to tighten.
•
Return blade wrench to storage area.
NOTE: Never use a blade that is too thick to allow the
outer blade washer to engage with the flats on the
spindle.
SPINDLE
LOCK BUTTON
LOWER BLADE
GUARD HANDLE
BLADE
J
INNER
BLADE WASHER
BLADE WASHER
BLADE SCREW
Fig. 2
12